Close Topic Options

OH! OH!!!! I KNOW THIS ONE!!!!!

Uhh It's his AC right? His AC broke. Yup, that's definitely it.


BHGs are so fun

This post has been edited by Blue-Sensei on Feb 27 2014, 06:54 PM

If you had grey texted that it would have been so funny because no one would have ever seen it.

Gray is visible

Blue is a bit harder

Little update to the side project.

Nick, the kid im helping with his Supra. He brought his head over from the machine shop were we reinstalled the cams, and proceeded to install new studs, and coat all studs in anti seize.

Man that head is super clean, he should be really happy with that.

Heres Nick holding his HG ready to put his baby back together.



FIPG oozing HG Goodness



Nick torqued his own head down with the help of "The Kusanagi" 90ft lbs in three steps 30-60-90 then cycling them 3 times.



before I left he managed to get this far by the end of the day. Not bad Nick not bad

Man, aint she clean?

Yes indeed, here we are 10am she breathes a sign of life once again.

finally out

I bet you're going to think you have a Caterham upon re-installation.

Itll be better than a Caterham lol

Stuntin' around Texas getting on the women with the legwarmers and poofy hair!

You better be blasting https://www.youtube.com/watch?v=bDbpzjbXUZI on your nexy Sunday drive.

after fighting with the tie rods for the better half of the day I finally got them off. Looser than a 60yr old porn start. The moog replacements should be nice.


[ Post merged on Mar 20 2014, 07:28 PM ]
Welp put the new tie rods in.



the old ones were soooo past it.



http://img.photobucket.com/albums/v436/Cob...zps5dbc5034.jpg

just need to torque em down and stake the washers. Hopefully with new inner and outer tie rods this thing will feel solid again.

Well, the start of collecting the bits for my fuel upgrade is underway. I acquired a HKS VPC and GCC for a Pre89 for a good price. The VPC harness that runs through the engine bay was a little baked so I decided to replace all the cooked wire back to a point where it was still soft. Decided to replace the cracked and flaking sleeve that wrapped the wires with Nylon braided sleeve (said it was rated to 302'F). Came out pretty nice if I say so myself.

Image size reduced, original size: 1024 x 768. Click here to view the image in its original dimension.

Image size reduced, original size: 1024 x 768. Click here to view the image in its original dimension.

Mustve been on something hot

Image size reduced, original size: 1024 x 768. Click here to view the image in its original dimension.

Image size reduced, original size: 1024 x 768. Click here to view the image in its original dimension.

Image size reduced, original size: 1024 x 768. Click here to view the image in its original dimension.

Image size reduced, original size: 1024 x 768. Click here to view the image in its original dimension.

Image size reduced, original size: 1024 x 768. Click here to view the image in its original dimension.

Image size reduced, original size: 1024 x 768. Click here to view the image in its original dimension.

Image size reduced, original size: 1024 x 768. Click here to view the image in its original dimension.

Nice shot of the sleeve and new wiring

Image size reduced, original size: 1024 x 768. Click here to view the image in its original dimension.

Image size reduced, original size: 1024 x 768. Click here to view the image in its original dimension.

Still deciding if I want to run my Bosch 040 or use a Denso TT pump.